How to Install MATRÉVOL Custom-Fit Seat Covers

There are no printed instructions in the box. The vehicle shown may be slightly different from yours, but the general steps are the same.

Before fitting, check the front seats, rear seats, headrests, centre console cover, armrests, seat belt cut-outs, ISOFIX cut-outs, airbag tags, buttons, and seat controls. If a cut-out or piece does not look right, please contact us before installing that piece.

The covers are designed to fit firmly, but they should be worked into place slowly and evenly. Start by lining up the cover, then adjust it section by section around the seat. Avoid yanking or forcing one area, as this can put too much pressure on the stitching, straps, or perforated sections.

These areas are designed to hold the cover in place once fitted, not to pull the cover into position. Pulling too hard on these areas can cause damage.

When tucking the covers around plastic trim, seat edges, or tight spaces, use gentle pressure and avoid sharp edges catching the leather, stitching, or perforated sections. You can also place a soft cloth over the end of the trim tool to help reduce the risk of marks or damage.

If a piece feels too tight, a cut-out does not line up, a headrest or console cover seems incorrect, or you’re unsure where something goes, please contact us before continuing. We can check photos, confirm positioning, and help avoid unnecessary damage during installation.